Tool borrowing?

[joestang]

Hey everyone. Anyone have a very low in-lb torque wrench I may borrow?

I'm replacing the pinion seal in my car, and realized the bearing preload that you have to check and re-torque to at a later time, is between 8 - 14 in-lbs. (very low).

I was thinking of using my ft-lb, starting at 0 and see when it clicks, but I'd like to use the right tool for the job if possible.

So.... anyone local to Westminster have one I can borrow. I can swing by and pick it up before dark-ish tonight or whenever. (after dark the motorcycle turns into a pumpkin and slides on the ice).

Thanks. Just give a call if I'm not online... 240-461-0655

-Joe

[bell]

I have one but am in highlands ranch, your welcome to it though

[RagingAardvark]

Joe,
I've got one two lower rated wrenches, but I'm out of town till Wed night. One of them is measured with inch-lbs ;)

[fhudsonjr]

Joe, I have a one, but the lowest setting is 20 in. lbs.

I remembered I have an inch lb. torque limiting screwdriver. It uses 1/4" male hexagon inserts.

I don't know if that would for you.

If so call me 720-280-3805

[joestang]

Thanks guys.
I found another Mustang buddy who has every and any tool, so I'm going to borrow his.
Thanks again for the offers!